Western HTS Owner's Manual page 36

Function Time-Outs
All control functions, except LOWER/FLOAT, time
out (stop) automatically after a period of time. This
is to limit the amount of electrical energy required
from the vehicle.
NOTE: If control function times out before
desired blade movement is complete, release
the lever to the center position, then move
back into the desired function.
Automatic Shutdown
The control will automatically turn OFF after being
idle for 20 minutes. To reactivate the control after
a shutdown, move the ON/OFF switch to OFF,
then back to ON.
Lit. No. 49513, Rev. 00
OPERATING YOUR SNOWPLOW
Smooth Stop
The control automatically allows the blade to coast
to a stop when the lever returns to center position.
This results in smoother operation, reduces the
shock to the hydraulic system and increases
hose and valve life. See "FLEET FLEX Electrical
System" in this section for more information.
Control Lever Movement
From the center position, the control lever can
be moved in one of eight (8) directions to control
various movements of the snowplow blade.
To change from one movement of the blade to
another, the control lever must be moved back to
the center position before selecting the desired
function. Whenever the lever is released, it should
spring back into the center position to stop any
blade movement.
37 August 15, 2011