Western HTS Owner's Manual page 47

Wing Positions
Moving the control lever from the center position
toward the word WING on either side of the face
of the control body will cause either wing to move
independently of the other as described in the
following table.
NOTE: If control function times out before
desired blade movement is complete, release
the lever to the center position, then move
back into the desired function.
SECURITY GUARD™ System (1, 2, 3, 4)
Moving the control lever from the center
position toward any of the four digits on the
face of the control body will also operate
the SECURITY GUARD system. See
"SECURITY GUARD System" in this section for
more information.
Lit. No. 49513, Rev. 00
OPERATING YOUR SNOWPLOW
Function Description of Operation
Move the control lever toward the left side
of LOWER on the control face to move
the left wing. The fi rst time the lever is
moved into the slot after the control is
turned ON or another function is used,
L WING the wing will extend. Repeated use of
lever in the same slot, without using
another function, results in movement in
the opposite direction from the previous
movement. Function times out after
3.75 (OUT) or 3.25 seconds (IN).
Move the control lever toward the right
side of LOWER on the control face to
move the right wing. The fi rst time the
lever is moved into the slot after the
control is turned ON or another function is
R WING used, the wing will extend. Repeated use
of lever in the same slot, without using
another function, results in movement in
the opposite direction from the previous
movement. Function times out after
3.75 (OUT) or 3.25 seconds (IN).
48 August 15, 2011