Joystick Control - Western HTS Owner's Manual

MVP PLUS™ & WIDE-OUT™

JOYSTICK CONTROL

WARNING
To prevent accidental movement of the
blade, always move the ON/OFF switch to
OFF whenever the snowplow is not in use.
The power indicator light will turn OFF.
1. Turn the vehicle ignition switch to the "ON" or
"ACCESSORY" position.
2. Move the ON/OFF switch on the side of
the control to the "ON" position. The power
indicator light glows red, indicating the control
is ON. The indicator light glows red whenever
the control and the vehicle ignition switch are
both ON and the electrical connections to the
snowplow are completed.
The ON/OFF switch operates as an
emergency stop if required.
Lit. No. 49513, Rev. 00
OPERATING YOUR SNOWPLOW
Power Indicator
Light (red)
ON/OFF Switch
(Emergency Stop)
NOTE: If control function times out before
desired blade movement is complete, release
the lever to the center position, then move
back into the desired function.
44
FLOAT Light
(green)
ON/OFF FLOAT
RAISE
SCOOP RETRACT
1
L
3
WING WING
LOWER
August 15, 2011
2
R
4