Configuring The Thresholds For Otu Performance Monitoring Parameters - Cisco ASR 9000 Series System Configuration Manual

Configuring the Performance Monitoring Thresholds for the Satellite nV Optical System
• fc-fe
• fc-ne
• ses-fe
• ses-ne
• sesr-fe
• sesr-ne
• uas-fe
• uas-ne
Step 6
commit
Configuring the Thresholds for OTU Performance Monitoring
Parameters
Perform this task to configure the thresholds for OTU Performance Monitoring (PM) parameters.
SUMMARY STEPS
1. configure
2. controller otu [HO | LO] R/S/I/P
3. pm [15-min | 24-hour] [fec | otn] [report | threshold] [ec-bits | uc-words] disable
4. pm [15-min | 24-hour] [fec | otn] [report | threshold] threshold-type value
5. commit
DETAILED STEPS
Step 1 configure
Step 2 controller otu [HO | LO] R/S/I/P
Example:
RP/0/RSP0/CPU0:router (config)# controller otu4 100/3/0/1
Enters the OTU4 controller configuration mode. Performance monitoring is enabled by-default for OTU controllers.
Step 3
pm [15-min | 24-hour] [fec | otn] [report | threshold] [ec-bits | uc-words] disable
Example:
RP/0/RSP0/CPU0:router (config-otu1)# pm 15-min fec report ec-bits disable
Specifies the PM interval for the OTU controller and set report value for the FEC layer.
Step 4 pm [15-min | 24-hour] [fec | otn] [report | threshold] threshold-type value

Configuring the Thresholds for OTU Performance Monitoring Parameters

Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
129