Configuring the Satellite Network Virtualization (nV) System
member
neighbor 70.0.0.1
!
!
!
!
mpls ldp
router-id 70.0.0.2
address-family ipv4
discovery targeted-hello accept
!
interface TenGigE0/0/0/1
!
!
Configuring ICCP Interface IP Address on Host A:
interface TenGigE0/0/0/1
ipv4 address 70.0.0.1 255.255.255.0
!
Configuring ICCP Interface IP Address on Host B:
interface TenGigE0/0/0/1
ipv4 address 70.0.0.2 255.255.255.0
!
SyncE Configuration:
In general, the Frequency Synchronization is configured in global mode for Host A, Host B, and downSsream
device (ASR 9000).
Configuring Frequency Synchronization in Global mode on Host A:
By default, QL option 1 is supported with the frequency synchronization configuration in global mode. In
addition, you can also explicitly configure QL option 1 or 2 as:
frequency synchronization
quality itu-t option 2 generation 2
!
Configuring Frequency Synchronization in Global mode on Host B:
frequency synchronization
quality itu-t option 2 generation 2
!
Configuring Frequency Synchronization in Global mode in downstream Device (ASR 9000):
frequency synchronization
quality itu-t option 2 generation 2
clock-interface timing-mode system
!
Configuring Clock Interface on Host A:
clock-interface sync 0 loca 0/RSP0/CPU0
port-parameters
bits-input e1 crc-4 sa4 hdb3
!
frequency synchronization
selection input
priority 1
wait-to-restore 0
ssm disable
quality receive exact itu-t option 2 generation 2 PRS
!
!
Configuring Clock Interface on Host B:
clock-interface sync 0 loca 0/RSP0/CPU0
port-parameters
bits-input e1 crc-4 sa4 hdb3
!
frequency synchronization
selection input
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
Configuration Examples of SyncE on ASR9000 Hosts
51