Cisco ASR 9000 Series System Configuration Manual page 52

Configuring the Inter-Chassis Links and IP Connectivity
Command or Action
Step 4
host-priority <0-255>
Example:
RP/0/0RSP0/CPU0:router(config-redundancy-iccp-group)#
host-priority 128
Step 5 nv satellite system-mac <mac_address>
Example:
RP/0/0RSP0/CPU0:router(config-redundancy-iccp-group)#
nv satellite system-mac dcddc.dcdc.dcdc
Step 6 interface interface-name
Example:
RP/0/0RSP0/CPU0:router(config)# interface
TenGigE0/2/1/0
Step 7 ipv4 point-to-point
Example:
RP/0/0RSP0/CPU0:router(config-if)# ipv4 point-to-point
Step 8
ipv4 unnumbered loopback0
Example:
RP/0/0RSP0/CPU0:router(config-if)# interface
unnumbered loopback0
Step 9 nv
Example:
RP/0/0RSP0/CPU0:router(config-if)# nV
Step 10
satellite-fabric-link network
Example:
RP/0/0RSP0/CPU0:router(config-if-nV)#
satellite-fabric-link network
Step 11 redundancy iccp-group
Example:
RP/0/0RSP0/CPU0:router(config-sfl-network)# redundancy
iccp-group 2
Step 12 satellite <satellite id>
Example:
RP/0/0RSP0/CPU0:router(config-sfl-network)# satellite
500
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
42
Configuring the Satellite Network Virtualization (nV) System
Purpose
(Optional) Specifies the priority for the satellite on each
of the host. The host with the lower priority is preferred
as the active host. The default priority is 128.
(Optional) Specifies the MAC address. Two hosts in
the same redundancy group will sync up the system
MAC address and satellite priority information. The
System MAC must be the same. If it is different, then
the Host with low chassis MAC gets priority. If the
system MAC is not configured, then it uses low host
chassis MAC as the system MAC.
The supported inter-chassis link interface types are
limited by the connectivity provided on the supported
satellites. GigabitEthernet, TenGigE, and Bundle-Ether
interfaces are the only support ICL types.
(Optional) Configures the IPv4 point to point address.
(Optional) Configures the IPv4 loopback address on
the interface.
Enters the nV satellite mode.
Specifies the network type of ICPE inter-chassis link.
Configures the ICCP redundancy group.
Specifies the satellite ID of the satellite.