Configuring The Inter-Chassis Links In A Dual Home Network Topology - Cisco ASR 9000 Series System Configuration Manual

Configuring the Satellite Network Virtualization (nV) System
Command or Action
Example:
RP/0/0RSP0/CPU0:router(config)# end or
RP/0/0RSP0/CPU0:router(config)# commit

Configuring the Inter-Chassis Links in a Dual Home Network Topology

These are the steps for configuring Inter-chassis links in the case of a dual home topology.
Before You Begin
MPLS LDP needs to be up and running between the two hosts for the dual home configuration.
DETAILED STEPS
Command or Action
Step 1
configure
Example:
RP/0/RSP0/CPU0:router# configure
Step 2 interface interface-name
Example:
RP/0/RSP0/CPU0:router(config)# interface
TenGigE0/2/1/0
Purpose
For information on QoS configuration on ICLs , see Cisco ASR 9000
Series Aggregation Services Router Modular Quality of Service
Configuration Guide.
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
Configuring the Inter-Chassis Links and IP Connectivity
• When you issue the end command, the system prompts you to
commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
- Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and returns
the router to EXEC mode.
- Entering no exits the configuration session and returns the
router to EXEC mode without committing the configuration
changes.
- Entering cancel leaves the router in the current configuration
session without exiting or committing the configuration changes.
• Use the commit command to save the configuration changes
to the running configuration file and remain within the
configuration session.
Purpose
Enters global configuration mode.
The supported inter-chassis link interface types are limited
by the connectivity provided on the supported satellites.
GigabitEthernet, TenGigE, and Bundle-Ether interfaces
are the only support ICL types.
39