Additional References; Related Documents - Cisco ASR 9000 Series System Configuration Manual

Configuring the nV Edge System on the Cisco ASR 9000 Series Router
Note The DSC role is used for tasks that only need to be completed once in the system, such as apply the
configuration or perform installation activities.
The role of primary RSP is determined by the order the racks and the RSPs are booted.
Note

Additional References

The following sections provide references to related documents.

Related Documents

Related Topic
Cisco IOS XR master command reference
Satellite System software upgrade and downgrade on
Cisco IOS XR Software
Cisco IOS XR interface configuration commands
Satellite Qos configuration information for the Cisco
IOS XR software
Layer-2 and L2VPN features on the Satellite system
Layer-3 and L3VPN features on the Satellite system
Multicast features on the Satellite system
Broadband Network Gateway features on the Satellite
system
• RSP1 on rack 0 is a non-DSC and the standby RSP for the rack.
• RSP0 on rack 1 is a non-DSC and the standby RSP for the rack.
• RSP1 on rack 1 is the backup-DSC and the active RSP for the rack.
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
Document Title
Cisco IOS XR Master Commands List
Cisco ASR 9000 Series Aggregation Services Router
Getting Started Guide
Cisco ASR 9000 Series Aggregation Services Router
Interface and Hardware Component Command
Reference
Cisco ASR 9000 Series Aggregation Services Router
Modular Quality of Service Configuration Guide
Cisco ASR 9000 Series Aggregation Services Router
L2VPN and Ethernet Services Configuration Guide
Cisco ASR 9000 Series Aggregation Services Router
MPLS Layer 3 VPN Configuration Guide
Cisco ASR 9000 Series Aggregation Services Router
Multicast Configuration Guide
Cisco ASR 9000 Series Aggregation Services Router
Broadband Network Gateway Configuration Guide
Additional References
153