Cisco ASR 9000 Series System Configuration Manual page 95

Configuring QoS on the Satellite System
Command or Action
Step 8
exit
Example:
RP/0/RSP0/CPU0:router(config-pmap)# exit
Step 9 end-policy-map
Example:
RP/0/RSP0/CPU0:router(config-pmap)# end-policy-map
Step 10 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface TenGigE
0/1/0/0
Step 11
nv
Example:
RP/0/RSP0/CPU0:router(config-if)# nv
Step 12 satellite-fabric-link satellite satellite_id
Example:
RP/0/RSP0/CPU0:router(config-if-nV)#
satellite-fabric-link satellite 100
Step 13
remote-ports interface_type remote_subslot
Example:
RP/0/RSP0/CPU0:router(config-satellite-fabric-link)#
remote-ports Satellite-Ether 0/0/0-9
Step 14
service-policy output policy-map
Example:
RP/0/RSP0/CPU0:router(config-satellite-fabric-link)#
service-policy output policy3
Step 15 commit
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
Offloading Service-policy on Physical Satellite Fabric Link
Purpose
Returns the router to policy map configuration mode.
Ends the policy map configuration.
Configures an interface and enters the interface
configuration mode.
Enters the satellite network virtualization (nV)
configuration submode.
Specifies an interface as an Interface Control Plane
Extender(ICPE) inter-chassis link (ICL).
The Interface Control Plane Extender(ICPE)
Note
infrastructure has a mechanism to provide the
Control Plane of an interface physically located
on the Satellite device in the local Cisco IOS
XR software.
Configures the remote satellite ports 0 to 9.
Attaches a policy map to an output interface to be used
as the service policy for that interface.
85