Configuring A Satellite Nv System In Layer 2 Fabric Network Topology; Configuring Radius Filter-Id Attribute Direction: Example; Verifying Radius Filter-Id Attribute Direction; Configuring Nv Satellite Auto Image Upgrade: Example - Cisco ASR 9000 Series System Configuration Manual

Configuring a Satellite nV System in Layer 2 Fabric Network Topology

!
!
!
Configuring a Satellite nV System in Layer 2 Fabric Network Topology
interface TenGigE0/0/0/0.102
ipv4 point-to-point
ipv4 unnumbered Loopback0
load-interval 30
encapsulation dot1q 102
nv
satellite-fabric-link satellite 300
ethernet cfm
!
redundancy
!
remote-ports GigabitEthernet 0/0/0-10

Configuring RADIUS Filter-ID Attribute Direction: Example

The following example shows how to configure RADIUS filter-ID attribute direction:
configure
radius-server attribute 11 default direction inbound
!

Verifying RADIUS Filter-ID Attribute Direction

Use the show running-config aaa command to verify the RADIUS filter-ID attribute direction configuration.
show running-config aaa
radius-server host 10.1.0.3 auth-port 1645 acct-port 1646
key 7 104D000A0618
radius-server attribute 11 default direction inbound
aaa group server radius SG1
server 10.1.0.3 auth-port 1645 acct-port 1646
.
.
.

Configuring nV Satellite Auto Image Upgrade: Example

The following example shows how to configure nV satellite auto image upgrade:
config
nv satellite 100 upgrade on-connect
!
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
72
continuity-check interval 10ms
iccp-group 10
Configuring the Satellite Network Virtualization (nV) System