Cisco ASR 9000 Series System Configuration Manual page 48

Configuring the Inter-Chassis Links and IP Connectivity
This configuration shows the use of the global default VRF. The recommended option is to use a private
Note
VRF for nV IP addresses as shown in the
under Configuration Examples for Satellite nV System.
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/0RSP0/CPU0:router# configure
Step 2
interface interface-name
Example:
RP/0/0RSP0/CPU0:router(config)# interface
TenGigE0/2/1/0
Step 3 description
Example:
RP/0/0RSP0/CPU0:router(config-interface)#
description To Sat5 1/46
Step 4
ipv4 point-to-point
Example:
RP/0/0RSP0/CPU0:router(config-interface)#
ipv4 point-to-point
Step 5 ipv4 unnumbered loopback0
Example:
RP/0/0RSP0/CPU0:router(config-interface)#
interface unnumbered loopback0
Step 6
nV
Example:
RP/0/0RSP0/CPU0:router(config-if)# nv
Step 7 satellite-fabric-link satellite <id>
Example:
RP/0/0RSP0/CPU0:router(config-int-nv)#
satellite-fabric-link satelite 200
Step 8 remote-ports interface-type
Example:
RP/0/0RSP0/CPU0:router(config-int-nv)#
remote-ports GigabitEthernet 0/0/0-30
Step 9 end or commit
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
38
Configuring the Satellite Network Virtualization (nV) System
Satellite Management Using Private VRF, on page 67
Purpose
Enters global configuration mode.
The supported inter-chassis link interface types are limited by the
connectivity provided on the supported satellites. GigabitEthernet,
TenGigE, and Bundle-Ether interfaces are the only support ICL types.
Specifies the description of the supported inter-chassis link interface
type.
(Optional) Configures the IPv4 point to point address.
(Optional) Configures the IPv4 loopback address on the interface.
Enters the Network Virtualization configuration mode.
Specifies that the interface is an ICPE inter-chassis link.
Configures the remote satellite ports 0 to 30.
Saves configuration changes.
subsection