Auto-Ip - Cisco ASR 9000 Series System Configuration Manual

Configuring the Satellite Network Virtualization (nV) System
Command or Action
Step 13
remote-ports interface-type
Example:
RP/0/0RSP0/CPU0:router(config-sfl-network)#
remote-ports GigabitEthernet 0/0/9,5
Step 14 satellite <satellite id>
Example:
RP/0/0RSP0/CPU0:router(config-sfl-network)# satellite
600
Step 15 remote-ports interface-type
Example:
RP/0/0RSP0/CPU0:router(config-sfl-network)#
remote-ports GigabitEthernet 0/0/9,5
Step 16 end or commit
Example:
RP/0/0RSP0/CPU0:router(config)# end or
RP/0/0RSP0/CPU0:router(config)# commit

Auto-IP

The Auto IP feature improves the plug-and-play set up of an nV satellite system. With the Auto IP feature,
IP connectivity to the satellite is automatically provisioned. As a result:
• The nV Satellite Loopback interface is created on the host
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
Configuring the Inter-Chassis Links and IP Connectivity
Purpose
Configures the remote satellite ports for the satellite
500.
Specifies the satellite ID of the connected satellite in
the simple ring..
Configures the remote satellite ports for the satellite
600.
Saves configuration changes.
• When you issue the end command, the system
prompts you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
- Entering yes saves configuration changes to the
running configuration file, exits the configuration
session, and returns the router to EXEC mode.
- Entering no exits the configuration session and
returns the router to EXEC mode without
committing the configuration changes.
- Entering cancel leaves the router in the current
configuration session without exiting or
committing the configuration changes.
• Use the commit command to save the
configuration changes to the running
configuration file and remain within the
configuration session.
43