Attach Hierarchical Policies to the Interface
SUMMARY STEPS
1. interface type interface-path-id
2. ipv4 point-to-point
3. ipv4 unnumbered interface-type interface-instance
4. nv
5. satellite-fabric-link network
6. redundancy iccp-group group-number
7. satellite satellite-id
8. remote-portsinterface_type remote_subslot
9. service-policy output parent-policy-map-name
10. commit
11. exit
DETAILED STEPS
Command or Action
Step 1
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface
GigabitEthernet0/2/0/1
Step 2
ipv4 point-to-point
Example:
RP/0/RSP0/CPU0:router(config-if)# ipv4 point-to-point
Step 3
ipv4 unnumbered interface-type interface-instance
Example:
RP/0/RSP0/CPU0:router(config-if)# ipv4 unnumbered
Loopback10
Step 4
nv
Example:
RP/0/RSP0/CPU0:router(config-if)# nv
Step 5
satellite-fabric-link network
Example:
RP/0/RSP0/CPU0:router(config-if-nV)#
satellite-fabric-link network
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
98
Configuring QoS on the Satellite System
Purpose
Configures an interface and enters the interface
configuration mode.
Configures the IPv4 point to point address.
Enables IPv4 processing on a point-to-point interface
without assigning an explicit IPv4 address to that
interface.
Enters the satellite network virtualization (nV)
configuration submode.
Specifies the network type of Interface Control Plane
Extender(ICPE) inter-chassis link (ICL).