Cisco ASR 9000 Series System Configuration Manual page 50

Configuring the Inter-Chassis Links and IP Connectivity
Command or Action
Step 3
satellite-fabric-link satellite <id>
Example:
RP/0/RSP0/CPU0:router(config-interface)#
satellite-fabric-link satellite 100
Step 4 ipv4 point-to-point
Example:
RP/0/RSP0/CPU0:router(config-interface)# ipv4
point-to-point
Step 5
ipv4 unnumbered loopback0
Example:
RP/0/RSP0/CPU0:router(config-interface)# interface
unnumbered loopback0
Step 6 redundancy iccp-group
Example:
RP/0/RSP0/CPU0:router(config-interface)# redundancy
iccp-group 1
Step 7 minimum preferred links num
Example:
RP/0/RSP0/CPU0:router(config-satellite-fabric-link)#
redundancy minimum preferred links 2
(or)
RP/0/RSP0/CPU0:router(config-satellite-fabric-link)#
redundancy
RP/0/RSP0/CPU0:router(config-nV-red)# minimum
preferred links 2
Step 8 member neighbor 9.9.9.9
Example:
RP/0/RSP0/CPU0:router(config-interface)# member
neighbor 9.9.9.9
Step 9 backbone interface interface_type
Example:
RP/0/RSP0/CPU0:router(config-interface)# backbone
interface TenGigE0/1/0/3
Step 10
remote-ports interface-type
Example:
RP/0/RSP0/CPU0:router(config-int-nv)# remote-ports
GigabitEthernet 0/0/0-30
Step 11 end or commit
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
40
Configuring the Satellite Network Virtualization (nV) System
Purpose
Configures the ICPE inter-chassis link for the specified
satellite.
(Optional) Configures the IPv4 point to point address.
(Optional) Configures the IPv4 loopback address on the
interface.
Configures the ICCP redundancy group. In order to
configure multiple ICCP redundancy groups, repeat steps
6 through 10 with a different redundancy group number.
(Optional) Configures the minimum number of preferred
satellite fabric bundle-ether links. To configure this
parameter, the interface must be a bundle-ether interface.
If you do not enable this parameter on any host, then it is
assumed as 0 by default on that host. Hence, the decision
of failover is judged using that value. The range is 1 to
64.
You can either go to the redundancy mode to
Note
configure minimum preferred links or you can
specify redundancy keyword before configuring
the minimum preferred links.
Configures the LDP neighbor.
(Optional) Configures the backbone interface for the PE
isolation.
Configures the remote satellite ports 0 to 30.
Saves configuration changes.