Cisco ASR 9000 Series System Configuration Manual page 141

Configuring the Performance Monitoring Thresholds for the Satellite nV Optical System
DETAILED STEPS
Step 1 configure
Step 2
controller ethernet R/S/I/P
Example:
RP/0/RSP0/CPU0:router (config)# controller tenGigECtrlr 100/2/0/1
RP/0/RSP0/CPU0:router (config)# controller hundredGigECtrlr 100/3/0/1
Enters the ethernet controller configuration mode.
Step 3
pm {15-min | 24-hour} ether report threshold-type enable
Example:
RP/0/RSP0/CPU0:router (config-tenGigECtrlr)# pm 24-hour ether report in-Mcast enable
Specifies the PM interval for the ethernet controller and enables report value. threshold-type can have one of the following
values:
• fcs-err
• in-Ucast
• in-Mcast
• in-Bcast
• jabber-stats
• long-frame
• out-Bcast
• out-Mcast
• out-octets
• out-Ucast
• oversize-pkt
• 1024-1518-octets
• 128-255-octets
• 256-511-octets
• 512-1023-octets
• 64-octets
• 65-127-octets
• rx-pkt
• octet-stat
• tx-pkt
Step 4
pm {15-min | 24-hour} ether threshold threshold-type threshold-value
Configuring the Thresholds for Ethernet Performance Monitoring Parameters
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
131