Cisco ASR 9000 Series System Configuration Manual page 55

Configuring the Satellite Network Virtualization (nV) System
SUMMARY STEPS
1. configure
2. interface interface-name
3. nv
4. satellite-fabric-link satellite <id>
5. ethernet cfm
6. level
7. continuity-check interval time
8. end or commit
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/0RSP0/CPU0:router# configure
Step 2
interface interface-name
Example:
RP/0/0RSP0RP0/CPU0:router(config)# interface
Gigabit 0/1/0/0
Step 3 nv
Example:
RP/0/0RSP0/CPU0:router(config-if)# nV
Step 4 satellite-fabric-link satellite <id>
Example:
RP/0/0RSP0RP0/CPU0:router(config-int-nv)#
satellite-fabric-link satelite 200
Step 5 ethernet cfm
Example:
RP/0/0RSP0RP0/CPU0:router(config-int-nv)#
ethernet cfm
Step 6
level
Example:
RP/0/0RSP0RP0/CPU0:router(config-int-nv-cfm)#
level
Cisco ASR 9000 Series Aggregation Services Router nV System Configuration Guide, Release 5.3.x
Purpose
Enters global configuration mode.
Specifies the supported inter-chassis link interface types limited
by the connectivity provided on the supported satellites.
Enters the Network Virtualization configuration mode.
Specifies that the interface is an ICPE inter-chassis link.
Enters Ethernet Connectivity Fault Management (CFM)
configuration mode.
Specifies the CFM level. It ranges from 0 to 7.
Configuring the Fabric CFM
45