Starting The Scsiselect Utility Program; Choices Available From The Scsiselect Menu - IBM xSeries 200 Hardware Maintenance Manual

Starting the SCSISelect utility program

Complete the following steps to start the SCSISelect Utility
program:
1. Turn on the server.
2. When the <<< Press <CTRL><A> for SCSISelect
Utility! >>> prompt appears, press Ctrl+A.
3. When the Would you like to configure the host
adapter or run the SCSI disk utility? question
appears, make your selection and press Enter.
4. Use the arrow keys to select a choice from the menu.
v Press Esc to exit the SCSI Select Utility program.
v Press the F5 key to switch between color and
monochrome modes (if your monitor permits).
5. Follow the instructions on the screen to change the
settings of the selected items; then, press Enter.
Choices available from the SCSISelect
menu
The following choices appear on the SCSISelect Utility
menu:
v Configure/View Host Adapter Settings
Select this choice to view or change the SCSI controller
settings. To reset the SCSI controller to its default
values, press F6; then, follow the on-screen instructions.
You can view or change the following controller settings:
– Host Adapter SCSI ID
Select this choice to view the SCSI controller
identification (ID), which is usually 7.
– SCSI Parity Checking
Select this choice to view the assigned value of
Enabled.
– Host Adapter SCSI Termination
Select this choice to view the assigned value of
Automatic.
– Boot Device Options
Select this choice to configure startable-device
parameters. Before you can make updates, you must
know the ID of the device whose parameters you
want to configure.
– SCSI Device Configuration
Select this choice to configure SCSI-device
parameters. Before you can make updates, you must
know the ID of the device whose parameters you
want to configure.
38
Hardware Maintenance Manual: xSeries 200
™