Using Passwords; Using The Scsiselect Utility Program (Some Models); Starting The Scsiselect Utility Program - IBM IntelliStation M Pro 6233 Hardware Maintenance Manual

v Power Management Setup
v PC Health Status
v Save and Exit Setup
v Load Optimized Defaults
v Exit Without Saving

Using passwords

You can use any combination of up to seven characters (A–Z, a–z, and 0–9) for the
power-on password or the administrator password. When you have set one or both
of the passwords, record the passwords and keep them in a secure place.
If both a power-on and administrator password are set, you can type either
password at the password prompt that appears as you start the computer. However,
if you want to change the settings in the Configuration/Setup, you must type the
administrator password to access the full configuration menus. If you type the
power-on password, you can only view limited information in the
Configuration/Setup program.
If you forget the power-on password, you can regain access to the computer
through one of the following methods:
v Start the Configuration/Setup Utility program and change the power-on password.
v Change the jumper position on the complimentary metal oxide semiconductor

Using the SCSISelect Utility program (some models)

SCSISelect is a built-in, menu-driven configuration utility program that you can use
to:
v View the default SCSI IDs
v Locate and correct configuration conflicts
The following sections provide instructions for starting the SCSISelect Utility
program and descriptions of the menu choices that are available.

Starting the SCSISelect Utility program

Complete the following steps to start the SCSISelect Utility program:
1. Turn on the computer.
2. When the <<< Press <CTRL><A> for SCSISelect¬ Utility! >>> prompt
3. When the Would you like to configure the host adapter or run the SCSI
36
Hardware Maintenance Manual: IBM IntelliStation M Pro Type 6233 and 6850
Select this choice to enable or disable system power settings. This includes
automatic power-on settings such as Wake on LAN and Wake on Alarm.
Select this choice to display the computer temperature and voltage status.
Select this choice to save the customized settings.
Select this choice to discard the changes and restore the factory settings.
Select this choice if you want to exit without saving changes, or if no changes
have been made.
(CMOS) jumper as described in "Erasing a lost or forgotten password (clearing
CMOS)" on page 28.
displays, press Ctrl+A.
disk utility? question displays, make your selection; then, press Enter.