Guide Assembly / Speaker - IBM xSeries 200 Hardware Maintenance Manual

6. Disconnect the cable of the button kit from the system
board.
7. Place a screwdriver against the bottom release latch of
the button kit and gently press upward and slide the
latch through the aperture.
8. Gently pinch together the upper release latches and
slide the latches through the aperture and remove the
button kit.

Guide assembly / speaker

Before you begin:
v Read "Safety information" on page 125.
v Review the information in "Before you begin" on page
44.
To remove the speaker, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Remove the cover (see "Removing the side cover" on
page 46).
4. Remove the front bezel (see "Removing the bezel" on
page 48).
5. Remove the support bracket (see "Removing the
support bracket assembly" on page 49).
6. Remove all adapter cards.
7. Unplug the speaker from the system board.
Chapter 6. FRU information (service only)
93