Using The Boot Menu Program; Enabling The Intel Gigabit Ethernet Utility Program; Using The Scsiselect Utility Program (Some Models); Starting The Scsiselect Utility Program - IBM IntelliStation M Pro 6220 User Manual

If you set both a user password and an administrator password, you can type either
password at the password prompt that appears as you start your computer.
However, if you want to change the settings in the Configuration/Setup Utility
program, you must type the administrator password to access the full
Confirugation/Setup Utility menu. If you type the user password, you have access to
only the limited Configuration/Setup Utility menu.
Keep a record of your password in a secure place. If you forget the user or
administrator password, you can regain access to the computer through one of the
following methods:
v If you have forgotten the user password and an administrator password is set,
v Remove the battery and then install the battery (see "Replacing the battery" on

Using the Boot Menu program

The Boot Menu program is a built-in, menu-driven configuration utility program that
you can use to temporarily redefine the first startup device without changing
settings in the Configuration/Setup Utility program.
Complete the following steps to use the Boot Menu program to change the startup
sequence of your computer:
1. Turn off the computer.
2. Restart the computer.
3. Press F12.
4. Select the startup device.
The next time the computer is started, it returns to the startup sequence set in the
Configuration/Setup Utility program.

Enabling the Intel Gigabit Ethernet Utility program

The Intel Gigabit Ethernet Utility is part of the BIOS in your computer. You can use
it to configure the network as a startable device, and you can customize where the
network startup option appears in your startup sequence. Enable the Intel Gigabit
Ethernet Utility from the Configuration/Setup Utility program.
Complete the following steps to enable the Intel Gigabit Ethernet Utility program:
1. From the Configuration/Setup Utility main menu, select Devices and I/O Ports
2. Select System Board Ethernet PXE/DHCP and use the Right Arrow (→) key to
3. Select Save Settings and press Enter.

Using the SCSISelect Utility program (some models)

Use the SCSISelect Utility program to configure SCSI devices:

Starting the SCSISelect Utility program

Complete the following steps to start the SCSISelect utility program:
1. Turn on the computer.
26
IBM IntelliStation M Pro Types 6220 and 6230: User's Guide
type the administrator password at the power-on prompt. Start the
Configuration/Setup Utility program and change the user password.
page 106).
and press Enter.
set it to Enabled.