Installing A Hard Disk Drive In Bay 5, 6, Or 7 - IBM xSeries 200 Hardware Maintenance Manual

Note: Make sure to route the signal cable so that it
9. If you have other options to install or remove, do so
now.
10. Connect one of the power cables from the power
supply into the back of the drive. The connectors are
keyed and can be inserted only one way.
11. Replace the support bracket assembly and reconnect
the fan cable to the connector (SYSFA3) on the
system board. See "System board internal cable
connectors" on page 42 for the location of the fan
cable connector.
12. Reinstall the side cover, see "Installing the cover" on
page 70 for details.
13. Reconnect the external cables and power cords; then,
turn on the peripheral devices and the server.
Installing a hard disk drive in bay 5, 6,
or 7
Complete the following steps to install a hard disk drive in
bay 5, 6, or 7.
does not block the air flow to the rear of the
drives or over the microprocessor.
Chapter 5. Installing options
Drive cage retention tab
Drive cage release tab
59