No Beep Symptoms; Diagnostic Error Codes - IBM xSeries 200 Hardware Maintenance Manual

Beep/
Symptom
One Long
and Two
Short Beeps
Two Long
and Two
Short Beeps

No beep symptoms

No Beep
Symptom
No beep and
the system
operates
correctly.
No Beeps
occur after
successfully
completing
POST
No ac power
No beep and
no video

Diagnostic error codes

Note: In the following error codes, if XXX is 000, 195, or
197do not replace a FRU. The description for these
error codes are:
000
195
197
For all error codes, replace/follow the FRU/Action
indicated.
Error
Code/Symptom FRU/Action
001-XXX-000
(Failed core
tests)
FRU/Action
1. Video adapter (if present)
2. System Board
1. Video adapter
FRU/Action
1. Check speaker cables
2. Speaker
3. System board
1. Check speaker connections
2. Speaker
3. System board
1. Check the power cord.
2. Power supply.
1. See "Undetermined problems" on page
116
The test passed.
The Esc key was pressed to abort the
test.
This is a warning error and may not
indicate a hardware failure.
1. System Board
Chapter 7. Symptom-to-FRU index
103