Handle Assembly; Adapter Retainer - IBM xSeries 200 Hardware Maintenance Manual

6. Remove the four screws from the back of the server
and put them in a safe place.
7. Using a screwdriver, gently pry the cover away from
the server in the rear and slide the unit away from the
server.

Handle assembly

Before you begin:
v Read "Safety information" on page 125.
v Review the information in "Before you begin" on page
44.
To remove the handle cap, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Use a flathead screwdriver to gently press in and down
on the tabs located on the interior side wall of the
handle.
4. Lift up on the handle cap to separate it from the handle
support.
To remove the handle support, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Firmly grasp the handle support and slide it away from
the front bezel.
4. Lift up on the handle support to remove it from the
slots in the top of the chassis.

Adapter retainer

Before you begin:
v Read "Safety information" on page 125.
v Review the information in "Before you begin" on page
44.
96
Hardware Maintenance Manual: xSeries 200