Cd-Rom Drive - IBM xSeries 200 Hardware Maintenance Manual

To remove the system board, do the following:
1. Power-off the server, if it is on.
2. Unplug the server.
3. Remove the cover (see "Removing the side cover" on
page 46).
4. Remove the front bezel (see "Removing the bezel" on
page 48).
5. Remove the support bracket (see "Removing the
support bracket assembly" on page 49).
6. Disconnect the cables.
7. Remove the adapter cards and both adapter retaining
brackets (see "Installing an adapter" on page 51).
8. Remove the hot-swap hard disk drive cage (see "Hard
disk drive cage" on page 87).
9. Remove memory modules (see "Installing memory
modules" on page 61).
10. Remove microprocessors and/or terminator cards
(see "Removing and installing a microprocessor" on
page 63).
11. Remove screws and lift the system board out of the
server.

CD-ROM drive

Before you begin:
v Read "Safety information" on page 125.
v Review the information in "Before you begin" on page
44.
90
Hardware Maintenance Manual: xSeries 200