Table of Contents
Advertisement
Starting the Broadcom NetXtreme Gigabit Ethernet Boot Agent
The Broadcom NetXtreme Gigabit Ethernet Boot Agent program is a built-in
configuration utility program that you can use to configure the computer to start
from the network. You enable the Broadcom NetXtreme Gigabit Ethernet Boot Agent
program and establish your network as a startup device using the
Configuration/Setup Utility program.
Complete the following steps to enable Broadcom NetXtreme Gigabit Ethernet Boot
Agent:
1. Turn on the computer and watch the monitor screen.
2. When the message Press F1 for Configuration/Setup, Press F12 for Boot
3. From the Configuration/Setup Utility main menu, select Devices and I/O Ports
4. Select System Board Ethernet PXE/DHCP and use the Right Arrow (→) key to
5. Select Save Settings and press Enter.
For details about using the Configuration/Setup Utility program to configure the
computer to start from the network, see the User's Guide on the IBM IntelliStation
Documentation CD.
Starting the SCSISelect utility program (some models)
SCSISelect is a menu-driven configuration utility program that you can use to:
v View the default SCSI IDs
v Locate and correct configuration conflicts
Complete the following steps to start the SCSISelect Utility program:
1. Turn on the computer and watch the monitor screen.
2. When the <<< Press <CTRL><A> for SCSISelect Utility! >>> prompt appears,
3. When the prompt Would you like to configure the host adapter or run the
4. Use the arrow keys to select a choice from the menu.
5. Follow the instructions on the screen to change the settings of the selected
Starting the Boot Menu program
Complete the following steps to start the Boot Menu program:
1. Turn on the computer and watch the monitor screen.
2. When the message Press F1 for Configuration/Setup, Press F12 for Boot
3. Follow the instructions that appear on the screen.
Menu appears, press the F1 key.
and press Enter.
set it to Enabled.
press Ctrl+A.
SCSI disk utility? appears, make your selection and press Enter.
items; then, press Enter.
Menu appears, press the F12 key.
Chapter 3. Installing software
37
Advertisement
Table of Contents
