IBM xSeries 200 Hardware Maintenance Manual page 141

Electrical current from power, telephone and
communication cables is hazardous.
To avoid a shock hazard:
v Do not connect or disconnect any cables or perform
installation, maintenance, or reconfiguration of this
product during an electrical storm.
v Connect all power cords to a properly wired and
grounded electrical outlet.
v Connect to properly wired outlets any equipment
that will be attached to this product.
v When possible, use one hand only to connect or
disconnect signal cables.
v Never turn on any equipment when there is
evidence of fire, water, or structural damage.
v Disconnect the attached power cords,
telecommunications systems, networks, and
modems before you open the device covers, unless
instructed otherwise in the installation and
configuration procedures.
v Connect and disconnect cables as described in the
following table when installing, moving, or opening
covers on this product or attached devices.
To Connect
1. Turn everything OFF.
2. First, attach all cables to
devices.
3. Attach signal cables to
connectors.
4. Attach power cords to outlet.
5. Turn device ON.
v Statement 2
Chapter 9. Related service information
To Disconnect
1. Turn everything OFF.
2. First, remove power cords
from outlet.
3. Remove signal cables from
connectors.
4. Remove all cables from
devices.
131