Removing The Support Bracket Assembly - IBM xSeries 200 Hardware Maintenance Manual

Removing the support bracket
assembly
When working with some options such as hard disk drives,
microprocessors, and memory modules you must first
remove the support bracket assembly to access the
location of the option.
Complete the following steps to remove the support
bracket assembly:
1. Review the information in "Before you begin" on page
44.
2. Turn off the server and peripheral devices and
disconnect all external cables and power cords.
3. Disconnect the support bracket assembly fan cable
from the connector (SYSFA3) on the system board. For
the location of the fan connector, see "System board
internal cable connectors" on page 42.
4. Pull out, about 152.4 mm (6 in.), on the end of the
support bracket assembly located at the rear of the
server.
5. Pull the front end of the support bracket assembly
away from the server and place the assembly aside.
Chapter 5. Installing options
49