Otto Bock B500 Classic User Instructions page 50

Usage
Fig. 29 Image showing the release points
Removing the Recaro® seat from the mobility base
1) Loosen the left and right locking bolts on the seat frame.
To do this, pull the release strap under the seat bottom
forward and hold it (see Fig. 30, item 1).
2) To release the rear seat clip from the bracket, tip and
push the seat back slightly.
3) Remove the Recaro® seat.
→ The Recaro® seat has been removed.
Attaching the Recaro® seat to the mobility base
CAUTION
Recaro® seat not locked in place
Risk of tipping
50 | Ottobock
► During installation of the Recaro seat, ensure that the
seat clip is engaged firmly in the clips.
► Ensure that the front locking bolts are engaged up to
the key ring.
1) Set the back edge of the Recaro® seat onto the end of
the seat frame.
2) Push the seat forward until the rear seat clip protrudes
into the bracket.
10
3) Tip the seat forward until the locking bolts engage with
the seat frame (see Fig. 30, item 2).
180
CAUTION! Visually inspect and shake the seat to
ensure secure locking.
→ The Recaro® seat is installed.
B500 classic/advanced