Table of Contents
Advertisement
INSTALLATION & SETUP
Notes: 1) All serial connections require a 9 pin D connector at the projector end.
Refer to Appendix D for cable wiring requirements. 2) For computer/controller
control, PC software is required. 3) The RS-232 serial port labeled "OUT" is
provided for projector networking applications.
2.8 Optical
Optical alignment is required when the throw distance changes or the pro-
Alignment
jector cannot be focused using the focus controls. The projector is optically
aligned at the factory at a fixed screen size and a fixed projector-to-screen
distance. See Appendices F and G for the specific details needed for your
projector model and lens. If the throw distance has changed since the last
setup, proceed as follows:
Notes: 1) The projector must be warmed up for at least 45 minutes prior to
performing optical alignment. 2) Optical alignment is both a mechanical and
electrical adjustment. Electrical adjustments are stored in the current setup
memory. After alignment is complete, setup memories which were previously set
up (if any) must be set up again. Memory setup is explained in section 2.10. 3)
Factory alignment is performed using the internal crosshatch with a 61.8 kHz
signal applied.
It is recommended that optical alignment be performed using the projector's
Guided Mechanical Setup tutorial. This tutorial displays step-by-step
instructions during the alignment. The instructions in this section require
use of the Guided Mechanical Setup tutorial.
To access and use the Guided
Mechanical Setup tutorial, turn on
the projector (
) then press
POWER
HELP
at operation level. The Help menu
is displayed. Next press
to select
2
Guided Mechanical Setup. The first
page of the guide will be displayed on
the projection screen. When using
the guide, press
to display the
HELP
next page, press
to display the
RECALL
previous page. When complete, press
to end Help.
EXIT
Step 1 ➤
If you have not already done so, calculate the throw distance and set the
projector position as explained in section 2.4, Mounting. Turn power off
before moving the projector.
2.17
Advertisement
Table of Contents
