Table of Contents
Advertisement
OPERATION
3.7 Utility Features
3.34
Move bars until outside edge of
to move bars
Manual Learn Screen
box fits inside screen border.
<ENTER> to select bars to move
<CONV> to do Learn Screen
Current Bars: Top/Left
For each bar position being adjusted, watch the bar width as it moves closer
to the screen edge. If the bar starts to overlap the screen border and reduce
in width, move it back one increment so that it is displayed in its entirety. If
the bar is as far as it will go and it is displayed in its entirety, leave it at that
position. If you notice a geometry distortion during Learn Screen, such as
keystone or pincushion, use
When all bars have been adjusted, press
Screen operation. The remainder of the Learn Screen process is handled
automatically by ACON. Wait until it is complete, at which time the
ACON Auto-Convergence Menu is returned.
If an error occurs during either of the Learn Screen functions, processing
halts and an error message is displayed. Refer to section 4.3, Troubleshooting,
for assistance. Also, if during a Learn Screen you want to interrupt ACON,
press
. Shortly thereafter an Exit dialog box will be displayed. Follow the
EXIT
screen instructions to exit or continue.
The projector's utility features allow you to
customize operation of the projector to suit
your application and preferences. To access
these features, press
UTIL
is displayed.
Item 1, Source Setup, provides utilities for
setup memory manipulation and selection
of internal sources.
Item 2, Channel List, allows you to
program the Channel List.
Item 3, Recall Memories, displays a listing of the Recall memories stored in
the projector.
Item 4, Input Memories, displays a listing of the Input memories stored in
the projector.
to correct it.
GEOM
to continue with the Learn
CONV
. The Utilities menu
Move bars until outside edge of
to move bars
Manual Learn Screen
box fits inside screen border.
<ENTER> to select bars to move
<CONV> to do Learn Screen
Current Bars: Top/Left
Advertisement
Table of Contents
