Madrigal Imaging MP-8, MP-9 Owner's Manual page 17

Reverse Scan ➤
If the keypad is configured for IR remote operation, make sure the batteries
are installed. If it is configured for built-in or wired remote operation, make
sure its extension cable is properly connected to the projector. Perform the
following keystroke sequences to change its operating settings:
• To toggle the keypad's protocol setting (A or B),
press
BRITE TINT DETAIL
• To toggle the backlit feature (enable or disable),
press
BRITE TINT DETAIL
• To return all configuration settings to the jumper settings,
press
BRITE DETAIL
TINT
Note: The projector will not respond to keypad commands if you press
. If pressed accidentally, press
2
BRITE TINT DETAIL
all keystroke settings.
If the projector is not installed in a front screen, floor mount configuration,
reverse scan setup may be required. Reverse scan setup must be performed by a
qualified Madrigal Imaging service technician. Refer to Table 2-2 to determine
if reverse scan setup is required. Contact your dealer for assistance.
Table 2-2. Operating Configurations
OPERATING CONFIGURATION
.
1
.
3
.
0
Front Screen,
Floor Mount
(default configuration)
Front Screen,
Ceiling Mount
Rear Screen,
Floor Mount
Rear Screen,
Ceiling Mount
Rear Screen,
Floor Mount,
With Mirror
INSTALLATION & SETUP
to clear
BRITE TINT DETAIL 0
HORIZONTAL VERTICAL
SCAN SCAN
NORMAL NORMAL
REVERSED REVERSED
REVERSED NORMAL
NORMAL REVERSED
NORMAL NORMAL
2.11