Table of Contents
Advertisement
OPERATION
3.8 Multi-projector
In a multi-projector installation it is usually desired to have a single IR key-
pad control all the projectors in the system. This section explains the special
Functions
control functions available for such installations.
The Projector ➤
The Projector function allows you to select which projector in a group will
respond to IR keypad commands. To use this function, each projector in the
installation must first be assigned a unique projector number. Projector
numbers are assigned through the Communication Setup menu which is
accessed by pressing
on a built-in keypad or a wired remote key-
6
2
UTIL
pad. Once each projector has its own unique projector number, projectors in
the installation can be individually controlled using the same IR keypad.
To select a projector to solely respond to commands from an IR keypad,
press
followed by the projector's identity number. The specified projec-
PROJ
tor will be the only projector which will respond to the keypad. To enable
ALL projectors to listen to the IR keypad, press
.
PROJ
Note: One, two, or three digits may be entered for the projector number.
Response is immediate if all three digits are entered (i.e., 001). Otherwise,
leading zeros are assumed after a five second time-out.
can also be used
ENTER
when less than the full three digits are entered. For example,
2
ENTER
PROJ
immediately selects projector 002 for control.
3.51
Advertisement
Table of Contents
