Table of Contents
Advertisement
INSTALLATION & SETUP
Step 16 ➤
Step 17 ➤
Step 18 ➤
Step 19 ➤
Step 20 ➤
Step 21 ➤
2.22
Press
or
to adjust for best electrical focus at the center of the picture.
On the MP-9, loosen the three bolts labeled
"B". One is located on the top plate. The
other two are below the red lens.
On the MP-8, loosen the four bolts
labeled "A".
Loosen the two bolts labeled "B".
A red and green crosshatch is displayed. Move
the red lens so that the left and right edges of the
red crosshatch match the green.
On the MP-9, tighten the three bolts
labeled "B".
On the MP-8, tighten the two
bolts labeled "B".
On the MP-9, loosen the three bolts
labeled "D". One is located on the top plate.
The other two are below the blue lens.
On the MP-8, tighten the two bolts labeled "D".
A blue and green crosshatch is displayed. Move the
blue lens so that the left and right edges of the blue
crosshatch match the green.
B
G
Before
B
G
B
G
R
B
G
Before
B
G
R
R
After
B
G
R
R
B
G
R
R
B
G
R
After
Advertisement
Table of Contents
