Cleaning; Troubleshooting - Madrigal Imaging MP-8, MP-9 Owner's Manual

Ultra high resolution graphics projectors
Hide thumbs Also See for MP-8, MP-9:
Table of Contents

Advertisement

CON

4.2 Cleaning

Lens Cleaning ➤
Case Cleaning ➤
ACON Cleaning ➤
CON
4.3 Trouble-
shooting
Projector Response ➤
Problems
Symptom:
Cause/Remedy:
Symptom:
Cause/Remedy:
In rare instances, flashing lights can trigger an epileptic seizure. During
ACON usage persons with epilepsy should look away from the screen.
Clean the projector when required. Before cleaning, always unplug the
projector from the power outlet.
To avoid the risk of scratching the lenses, only clean the lenses if absolutely
required. A small amount of dust on the lenses will have very little effect on
picture quality. If the lenses must be cleaned, use a DRY soft cotton cloth.
Rub gently in a circular motion.
Clean the case with a soft dampened cloth. Use a mild commercial cleaner.
Do not use liquid or aerosol cleaners.
The lens on the ACON Locator Assembly is very tolerant to dust and
should only be cleaned if ACON performance is affected. Cleaning of the
lens (if required) must be performed with great care. Use a DRY soft cotton
cloth. Rub gently in a circular motion.
If the projector is not operating properly, note the symptoms of the problem
and use the following guide to assist you. If you cannot resolve the problem
yourself, contact your dealer for assistance.
Refer to the following if the projector is not responding to keypad commands.
The projector will not turn on when
is pressed. All back panel
POWER
lights are off. See Figure 4-1.
1) The power cord may be dis-
connected. Check the power
cord connection at the wall
outlet and the projector.
The projector will not turn on when
LED on the back panel is lit.
1)
may not have been held down long enough to initiate projector
POWER
power-up. Hold down
2) If using an IR keypad, ensure it is pointed at the screen or the front of
the projector. If the keypad is configured for built-in or wired usage,
make sure it is properly connected to the projector.
Figure 4-1. Rear Panel LEDs
is pressed. Only the amber
POWER
for at least one second to initiate power-up.
POWER
MAINTENANCE
4.3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mp-9

Table of Contents