Table of Contents
Advertisement
2.5 Power
Connection
2.6 Source
Connections
To apply power to the projector, plug
the AC line cord into the line input
socket located at the front panel of
the projector. Plug the three prong
end of the line cord in a grounded
AC outlet. Input voltage to the pro-
jector must be between 90 and 264
VAC, 50 or 60 Hz. The power source
must supply 650 watts of power to
the projector.
The projector includes a built-in RGB input interface for connection of
external RGB sources and audio equipment. This input interface is shown
in Figure 2-16. The built-in interface is not removable.
Figure 2-16. Projector Input Slots
Optional interface modules are available to accommodate other signal
types. These include a Composite/S-Video Module, an HDTV Input
Module, and a PC Analog Input Module. Any one of these can be installed
in slot 2. A Multi-Standard Decoder may be installed to add four additional
inputs to the system ("slots" 3 to 6). To further increase the number of
inputs, a signal switcher may be connected to the RGB interface in slot 1
to add 8 more sources to the system (9 switcher inputs replace one RGB
input). Other switchers may be connected to the first switcher for more
inputs. Brief descriptions of the above mentioned optional modules are
given in Appendix H, Interfaces. For additional details, contact your dealer
or Madrigal.
Figure 2-15. Power Connection
to projector's
control ports
PHASTLink
compatible
RS-232 in port
INSTALLATION & SETUP
90 - 264 VAC
50 - 60 Hz
2.15
Advertisement
Table of Contents
