Table of Contents
Advertisement
INSTALLATION & SETUP
2.34
Step 6
Press
to turn ASR on for the input. Now, each time the computer's
1
4
UTIL
graphics adapter switches operating modes, the projector will automatically
adjust its display settings to suit the new mode.
ASR Example #2
Refer to the system illustrated in Figure 2-24 below. Six different sources
are connected to a third party (non-Madrigal Imaging) signal switcher.
Under normal circumstances, the projector is not aware of source switches
made by the switcher. However, if ASR is turned on for the input, and a
Recall memory has been set up for each source device, the projector will
detect the external source switch and automatically select the appropriate
Recall memory. Even if Recall memories have not been set up but ASR is
on, ASR will try to adjust the display settings based on the settings of other
Input or Recall memories.
Source "C"
(setup parameters
saved in Recall
memory 03)
Source "B"
(setup parameters
saved in Recall
memory 02)
Source "A"
(setup parameters saved
in Recall memory 01)
Figure 2-24. ASR System Example #2
To prepare setup memories for this system, follow these steps:
Step 1
Connect the output of the signal switcher to a projector input. Select the
input using the Source command. For this example, press
select projector slot 1.
Source "D"
(setup parameters
saved in Recall
memory 04)
3rd Party Switcher
Source "E"
(setup parameters
saved in Recall
memory 05)
Source "F"
(setup parameters
saved in Recall
memory 06)
to
0
1
SOURCE
Advertisement
Table of Contents
