Table of Contents
Advertisement
INSTALLATION & SETUP
Step 2 ➤
2.18
Locate the front top
cover of the projector.
See Figure 2-19. Next,
position your hands above
the red and blue lenses
then grasp the cover.
Gently lift it until it is
released from its securing
latch. Slide the cover away
from the projector as shown
in Figure 2-20 below.
a) Lift front cover until
latch is released.
Figure 2-20. Front Top Cover Removal
Also remove the black decorative foam piece at the front of the lenses
(removal is optional). Remove the large allen head driver from the tool kit
provided with the projector. The driver is used for lens alignment.
Examine the lenses and hardware as shown in Figure 2-21a (or, for the
MP-8 model, see Figure 2-21b). Each lens consists of a rear section and a
front section. The rear section sets the optical focus at the center of the
image and is secured to the lens body by a wing nut at the top rear of the
lens assembly. The front section sets the focus at the corners and is secured
to the rear section by a wing nut at the top front of the lens assembly.
Top Plate
Securing Bolts
Center
Focus Adjust
Corner
Focus Adjust
Figure 2-21a. MP-9 Lens Assemblies - Top View
Figure 2-19. Front Top Cover
b) Slide cover forward.
D
C
C
Blue
Green
Front Top
Cover
Foam Piece
B
Red
Advertisement
Table of Contents
