Table of Contents
Advertisement
INSTALLATION & SETUP
Step 10 ➤
Step 11 ➤
Step 12 ➤
Step 13 ➤
2.28
Adjust C linearity as follows:
Press
or
until the horizontal line through the center of the crosshatch
is equally distant from the lines at the very top and bottom.
Press
or
until the center of the crosshatch is equally distant from the
vertical lines at the left and right edges.
Adjust S linearity as follows:
Press
or
until the height of each crosshatch square is equal from the top
to the bottom.
Press
or
until the width of each crosshatch square is equal from the left
to the right.
The source connected to the currently selected input should now be visible.
If there is no picture, check to see if the source is active.
Press , ,
or
to adjust phase until the picture is centered on
the screen.
Press , ,
or
to adjust the size of the picture. Ensure that objects in
your picture have the correct shape. For example, if there is a circle in your
picture, size should be adjusted until the circle is round, not oval.
Before
After
Before
After
After
Before
After
Before
Advertisement
Table of Contents
