Madrigal Imaging MP-8, MP-9 Owner's Manual page 55

Up/Down Channel ➤
Selection
The Source ➤
Message
The projector switches to, and displays, the source assigned to the channel
number. If an invalid switcher or slot number is assigned to the channel, a
warning message is displayed.
Example
Channel 08 in the Channel List was programmed to select a source connected
to slot 5 on switcher 3. To select this source, simply press
Note: If the Channel Select option in the Preferences menu (
to either "1 digit only " or "1 or 2 Digits", the preceding zero shown in the
example above does not have to be entered. For more information, refer to the
Preferences entry in Section 3.7.
This method of source selection also takes advantage of the Channel List
feature. It lets you quickly switch between channels programmed in the
Channel List by using the up and down arrow keys on the keypad.
To make a selection:
Press followed by
SOURCE
Each time an arrow key is pressed, a channel number (and name) is displayed
on the screen. When the channel number you want is displayed, simply wait
to allow the projector to switch to the source defined by the channel.
Notes: 1) If a channel specifies a switcher which does not exist, the channel is
considered invalid. 2) The Channel List utility allows you to flag the channels
to be used by the Up/Down Channel selection feature. For more information,
refer to the Channel List entry in section 3.7, Utility Features.
When is pressed
or
SOURCE RECALL
at operation level, and/or a
source switch is made, a source
message is briefly overlayed on
the projection screen. The
source message displays current
source information.
Notes: 1) If screen messages are turned off via the Preferences menu (
the source message is not displayed. 2) During input selection or Recall memory
selection (explained later), the message box displays numeric keypad entries as
they occur. In both cases, two digits must be entered. If only one digit is entered,
the message box will remain displayed until a second digit is entered or the
selection is cancelled by pressing
internal source message is displayed.
or .
Channel 01
IBM PC
Input 01
Recall 13
ASI S02-R06
. 3) When an internal source is in use, an
EXIT
OPERATION
.
0 8
) is set
UTIL 5 4
Channel Number
Source Name
Input Number
Recall Memory No.
ASI Message
),
2
UTIL 5
3.13