Table of Contents
Advertisement
Source with multiple
scan rates / operating
modes.
MODE
TYPE
FREQ. (H)
1
Text
31.5 kHz
2
Graphics
35.6 kHz
64.0 kHz
3
Graphics
110.0 kHz
4
Graphics
Figure 2-23. ASR System Example #1
To prepare setup memories for the above system, follow these steps:
Step 1
Select the input using the Source command. Press
projector slot 1.
Step 2
Press
twice to display the Current Input Parameters status page. Check to
see if ASR is off for the current input. If it is on, press
off for the input. (It is usually easier to prepare setup memories when ASR is
turned off.)
Step 3
At the computer, switch to an application which uses one of the graphics
adapter operating modes. Select an unused Recall memory as the current
setup memory. For example, to make Recall memory 01 the current setup
memory, press
RECALL
0
settings for the current graphics mode will be stored in the Recall memory.
Repeat this step for the remaining graphics adapter operating modes, storing
adjustments for them in Recall memories 02, 03 and 04. It is recommended
that the two extreme frequencies be set up first.
Step 4
Press
to make Input memory 01 the current setup memory then
0
1
SOURCE
press
to display the Clear Setup dialog box. Move the cursor to
1
5
UTIL
"Do It" then press
ENTER
input. Now Input memory 01 will not be used during an ASR search.
Step 5
Press
to lock Input memory 01 to prevent display or frequency
1
3
UTIL
changes to the Input memory.
RECALL#
01
02
03
04
. Make display adjustments as required. The display
1
to clear the display and frequency settings of the
INSTALLATION & SETUP
Input 01
to select
0
1
SOURCE
to turn ASR
UTIL
1
4
2.33
Advertisement
Table of Contents
