Table of Contents
Advertisement
OPERATION
3.48
To program or modify an event, first use the arrow keys to move the cursor
to the field you want to modify (for example, the Type field). Next use
and/or the number keys to modify that field. Details for field modification are
provided on the following pages. Modify each field in the row as necessary
making sure all fields for the event are valid and logical.
When all modifications have been made, press
to display the Exit dialog box. When the
EXIT
Exit box is first displayed the cursor bar is
positioned on "Save." Press
save the new changes. To return to the Programmable Events feature
box, move the cursor bar to "Continue Change" then press
discard your changes, move the cursor bar to "No Save" then press
or
.
returns you to the Clock/Events menu.
EXIT
ENTER
operation level.
The Type Field
The Type field shows the event to take place. With the cursor positioned on
the Type field press
ENTER
clear the entire event line. Events are described in Table 3-1 below.
EVENT
None
No programmed event.
Standby On
Turn Standby mode on.
Standby Off
Turn Standby mode off.
Power Off
Turn Power off.
Channel selection
Select a channel from the Channel List.
Source selection
Select an input.
ACON (Full)
Perform an ACON (full) auto-convergence.
ACON (Touchup)
Perform an ACON (touchup) auto-convergence.
ACON
Perform an ACON (center only)
(Center Only)
auto-convergence.
Channels Up
Switch to the next available channel from the
Channel List.
Channels Down
Switch to the prior available channel from the
Channel List.
Warmup
Perform a warm-up sequence:
1) Turn Standby mode off (if on).
2) Set Contrast to 20%, Brightness to 50%,
HSize to 80%, VSize to 80% and master
static focus to 100%
3) Display white field for 15 min.
4) Restore original display settings.
* Only valid entries are accepted.
or
to
ENTER
EXIT
to cycle through the available events. Press
Table 3-1. Type Field Events
DESCRIPTION
ENTER
. To
ENTER
ENTER
returns you to
EXIT
to
NOTES
* Use the number keys to enter
the channel #.
* Use the number keys to enter
the switcher # and slot #.
ACON module is required.
ACON module is required.
ACON module is required.
Cycles back to the first channel
after last channel is selected.
Cycles back to the last channel
after the first channel is selected.
Exit from warm-up occurs after
15 minutes or when the EXIT key
is pressed. Other keys which
stop warm-up are PROJ, *, UTIL,
CONV and RECALL. When
warm-up stops, all original
display settings are restored.
Advertisement
Table of Contents
