Table of Contents
Advertisement
OPERATION
Direct Channel ➤
Selection
3.12
SOURCE
Example 2
A single signal switcher is connected to the projector and a computer
is connected to slot 3 of the switcher. To display the computer output,
press
.
1
3
SOURCE
SOURCE
Switcher Number 1
The computer output
is connected to slot 3
of switcher number 1.
Note: If a switcher is connected to the projector, its inputs can be selected using
the switcher's front panel push buttons.
This method of source selection takes advantage of the Channel List feature
explained in section 3.7, Utility Features. The Channel List allows you to
assign a source to a 2-digit number, from 01 to 99.
Once you have assigned channel numbers to your sources, and the projector
is at operation level, you can select a source by pressing the 2-digit channel
number associated with it.
To select a channel, press
st
where:
= the 1
digit of the channel number
m
nd
= the 2
digit of the channel number
n
PROJECTOR
ON/OFF
STANDBY
1
2
3
4
5
6
7
8
9
ELECTROHOME
MARQUEE SIGNAL SWITCHER
INPUT
.
m
n
INPUT
The workstation output
is connected to
slot 1 of the projector.
The switcher output
is connected to
slot 1 of the projector.
Advertisement
Table of Contents
