Table of Contents
Advertisement
Interpolated ➤
Convergence
Within each zone, a central control point defines the position of each color
within the zone. You will notice that the center position within the box is
most sensitive to the adjustment. This is where the control point is located.
Continue using
to move to the next zone/color for adjustment. If you
ENTER
wish to go back to a previous zone, press . Once all 45 zones have been
converged an Exit dialog box is displayed, as shown below. If you wish to
exit prior to converging all 45 zones,
dialog box.
Note:
may be used instead of
CONV
When the Exit dialog box is first displayed,
the cursor bar is positioned on "Save." Press
,
or
to save the new settings. To
ENTER
EXIT
RECALL
re-perform the convergence, move the cursor
bar to "Continue Adjust" then press
the cursor bar to "No Save" then press
Press
from the Convergence Menu to select Interpolated Convergence.
2
Interpolated Convergence is performed in the same way as that described for
Guided convergence. The primary difference between Guided Convergence
and Interpolated Convergence is noticed during adjustment. In Interpolated
convergence, adjustments are not limited to single zones, but will affect larger
regions of the raster. Response is greatest within the displayed box and
decreases linearity towards zones which have already been converged in the
sequence. Interpolated convergence is recommended when converging a
source for the first time. This method can be much faster than guided conver-
gence. However, it is not recommended if only minor convergence alignment
is required.
will immediately display the Exit
EXIT
to change zones/colors, if preferred.
ENTER
. To discard your changes, move
ENTER
,
or
EXIT
ENTER
RECALL
OPERATION
.
3.29
Advertisement
Table of Contents
