Loading Originals - Kyocera FS-1024MFP Operation Manual

Loading Originals

Follow the steps below to load originals for copying, sending or storing.
Placing Originals on the Platen
You may place books or magazines on the platen in addition to ordinary sheet originals.
OPERATION GUIDE
1
Open the original cover.
NOTE:
Open the document processor. Before opening
the document processor, be sure that there are no
originals left on the original table or on the original eject
table. Originals left on the original table or on the
original eject table may fall off when the document
processor is opened.
Keep the document processor open if the original is 25
mm or thicker.
2
Place the original. Put the scanning side facedown
and align it flush against the original size indicator
plates with the back left corner as the reference
point.
3
Close the original cover.
IMPORTANT: Do not push the original cover forcefully
when you close it. Excessive pressure may crack the
platen glass.
Do not close the document processor when the original
is 25 mm or thicker. The connector of the document
processor will be removed form the machine.
NOTE:
Shadows may be produced around the edges
and in the middle of open-faced originals.
CAUTION:
Do not leave the document processor open
as there is a danger of personal injury.
Preparation before Use
2-29
2