Kyocera FS-1024MFP Operation Manual page 277

Transparency (OHP film)
Transparencies must be able to withstand the heat of printing. Transparencies must meet the following
conditions.
Criteria
Heat resistance
Thickness
Material
Dimensional accuracy
Squareness of corners
To avoid problems, use the manual feed tray for transparencies and load transparencies with the long side
facing the machine.
If transparencies jam frequently at output, try pulling the leading edge of sheets gently as they are ejected.
Cardstock
Burrs
Envelopes
Use the manual feed tray for envelopes.
Due to the structure of envelopes, printing evenly over the entire surface may not be possible in some cases.
Thin envelopes in particular may be wrinkled by the machine in some cases as they pass through. Before
purchasing envelopes in volume, try testing a sample to ensure the print quality.
Storing envelopes for a long period may cause them to become wrinkled. Thus, keep the package sealed until
you are ready to use them.
Keep the following points in mind.
Do not use envelopes with exposed adhesive. In addition, do not use the type of envelope in which the adhesive
is exposed after the top layer is peeled off. Serious damage may be caused if the paper covering the adhesive
comes off in the machine.
Do not use envelopes with certain special features. For example, do not use envelopes with a grommet for
winding a string to close the flap or envelopes with an open or film-covered window.
Do not allow more than ten envelopes remain in the top tray at once.
OPERATION GUIDE
Must withstand at least 190°C
0.100 to 0.110 mm
Polyester
±0.7 mm
90° ±0.2°
If the Hagaki paper is curled, straighten it before
loading. Printing onto curled Hagaki may cause jams.
Burrs
Use unfolded Oufuku Hagaki (available at post offices).
Some Hagaki may still have rough edges developed by
a paper cutter on the back side. Remove any such
rough edges by placing the Hagaki on a flat surface and
rubbing the edges gently a few times with a ruler.
Specifications
Appendix-11