Kyocera FS-1024MFP Operation Manual page 67

How to Load Originals
IMPORTANT: Before loading originals, be sure that there are no originals left on the original eject table.
Originals left on the original eject table may cause the new originals to jam.
OPERATION GUIDE
1
Adjust the original width guides to fit the originals.
2
Place the originals. Put the side to be scanned
face-up. Slide the leading edge into the document
processor as far as it will go.
IMPORTANT: Confirm that the original width guides
exactly fit the originals. If there is a gap, readjust the
original width guides. The gap may cause the originals
to jam.
Ensure that loaded originals do not exceed the
level indicator. Exceeding the maximum level may
cause the originals to jam (see the figure).
Originals with punched holes or perforated lines
should be placed in such a way that the holes or
perforations will be scanned last (not first).
Preparation before Use
2-31
2