Kyocera FS-1024MFP Operation Manual page 278

Thick Paper
Some thick paper may still have rough edges developed by a paper cutter on the back side. Remove any such
rough edges just as with Hagaki by placing the paper on a flat surface and rubbing the edges gently a few times
with a ruler. Printing onto paper with rough edges may cause jams.
NOTE:
If the paper is not supplied correctly even after it is smoothed, load the paper in the manual feed tray
with the leading edge raised a few millimeters.
Label
Be sure to feed labels from the manual feed tray.
For selecting labels, use extreme care so that the adhesive may not come in direct contact with any part of the
machine and that the labels are not easily peeled from the carrier sheet. Adhesives that stick to the drum or
rollers and peeled labels remaining in the machine may cause a failure.
When printing onto labels, you must be liable for the print quality and possible trouble.
Some label paper has large margins on the top sheet. When using such paper, do not peel these margins from
the carrier sheet before completing output.
Use label paper that conforms to the following specifications.
Top sheet weight
Appendix-12
Top sheet
Adhesive layer
Carrier sheet
Allowed
Item
Labels consist of three layers as shown in the
illustration. The adhesive layer contains materials that
are easily affected by the force applied in the machine.
The carrier sheet bears the top sheet until the label is
used. This composition of labels may cause more
problems.
The label surface must be covered completely with the
top sheet. Gaps between labels may cause peeling of
labels, resulting in a serious failure.
Not allowed
Top sheet
Carrier sheet
44 to 74 g/m²
Specifications
OPERATION GUIDE