Black Box LW0050A Manual page 79

CHAPTER 4: PCMCIA Adapter Installation, Setup, and Management
3. Enter the ESSID as defined in the Access Point (if using default ESSID, do not
change).
4. Reset/restart the computer.
T
ROUBLESHOOTING
The following paragraphs provide information that can help in the event of
problems encountered in the ODI drivers installation.
• It is important to note which net.cfg and brzwlan.ini is used. After installation
of new Novell client, two copies of brzwlan.ini, brzwlan.com, and net.cfg files
may exist, one in the Windows directory and another in the directory where
the Novell client is installed.
• If Card Services fails to provide correct memory and IRQ automatically, edit
net.cfg and use IRQ and MEM parameters.
• If the driver did not display a message Testing Device, this indicates that Card
Services failed to recognize the card or to provide the required information to
the driver. Check the Card Services information configuration.
• The driver reports an error in allocating IRQ or memory. The Card Services
failed to provide the required resources to the driver, or there are no
resources available. Reboot without EMM386 or other programs that may take
up the adapter memory region. Change the IRQ or MEM parameters in
net.cfg to force the driver to request specific resources.
• The driver reports errors in net.cfg or brzwlan.ini. The files are corrupt or you
are not in the correct directory.
• The yellow LED blinks and turns off after several seconds. The Access Point is
configured with incorrect parameters. Check the Access Point configuration.
The built-in antennas are not pulled out or the external antenna is not
attached to the PC card.
• The yellow LED does not blink and is not lit. The driver is not receiving
interrupts. Try to change IRQ—wrong firmware version or card initialization
error.
Default ESSID is ESSID1 in capital letters.
ODI I
NSTALLATION
NOTE
77