Access Point Leds; Verifying The Ethernet Connection - Black Box LW0050A Manual

PRO 11 SERIES WIRELESS ETHERNET
Name Description
QLT Quality of reception H, M, and L LEDs not lit: Very-low-quality reception (less
2.6.2 A P
CCESS OINT
Name Description
PWR power supply
INFR radio interference
ETHR Ethernet activity
LOAD WLAN load
(Number of
associated stations) H LED not lit, M and L LEDs lit: 9 to 16 stations.
2.6.3 V
ERIFYING THE
Once you have connected the unit to an Ethernet outlet, verify that the ETHR
LED on the front panel is blinking. The ETHR LED should blink whenever the
unit receives LAN traffic.
At the other end of the Ethernet link, verify that the LINK indicator is ON. On
Access Points, the LINK indicator is located on the attached hub port; on Station
Adapters, the LINK indicator is located on the NIC.
24
than -81 dBm) or not synchronized with Access Point.
H and M LEDs not lit, L LED is lit: Low-quality reception
(from -81 to -77 dBm), usually enabling 1-Mbps traffic.
H LED not lit, M and L LEDs lit: Medium-quality
reception (from -77 to -65 dBm), usually enabling 2-
Mbps traffic.
H, M, and L LEDs lit: High-quality reception (greater
than -65 dBm), enabling 3-Mbps traffic.
LED
S
On – After successful power-up
Off – Power off
Off – No interference
Blinking – Interference present
On – Reception of data from Ethernet LAN that is
forwarded to WLAN (in reject-unknown mode)
Off – No reception of data from Ethernet LAN that is
forwarded to WLAN
H, M, and L LEDs not lit: No stations.
H and M LEDs not lit, L LED lit: 1 to 8 stations.
H, M, and L LEDs lit: 17 or more stations.
E C
THERNET ONNECTION
Meaning
Meaning