Configuration Screens - Black Box LW0050A Manual

PRO 11 SERIES WIRELESS ETHERNET
To use Local Terminal Management:
1. Click an option number to open/activate the option. You may need to press
Enter in some cases.
2. Press Esc to exit a menu or option.
3. Reset the unit after making configuration changes.

3.2 Configuration Screens

Listed below are the menus, sub-menus, and sub-submenus in the terminal
program that the Installer can edit. Default values are listed where applicable.
Numbers in the table below indicate how to reach each option. For example, to
reach the 1.2.1 IP Address option, start at the main menu and press 1, then 2, and
then 1.
Menu Sub-Menu
1. System 1.1 Station
Config- Status
uration
1.2 IP and
SNMP
Parameters
1.3 Wireless
LAN (WLAN)
Parameters
* Option 1.3.5 Transmit Antenna has the default value Use #2 for the Four-Port Station Adapters only.
** Option 1.3.7 Load Sharing has the default value Enabled for the Access Points only.
26
Table 3-1. Configuration Menus
Sub-Submenu
1.2.1 IP Address
1.2.2 Subnet Mask
1.2.3 Default Gateway Address
1.2.4 SNMP Traps
1.2.5 Display Current Values
1.3.1 Hopping Sequence (only for Access Points)
1.3.2 Hopping Set (only for Access Points)
1.3.3 ESS ID
1.3.4 Maximum Data Rate
1.3.5 Transmit Antenna
1.3.6 Mobility
1.3.7 Load Sharing
1.3.8 Preferred AP (not available for Access Points)
1.3.A Display Current Values
Default Values
Enabled
1
1
ESSID1
3 Mbps
Use 2 Antennas*
Low
Disabled**